OSCILLATOR

www.DataSheet4U.com 9939 Via Pasar • San Diego, CA 92126 TEL (858) 621-2700 FAX (858) 621-2722 CLV6580A-LF VOLTAGE CONTROLLED OSCILLATOR Rev A1 PHASE NOISE (1 Hz BW, typical) FEATURES • Frequency Range: 6390 - 6770 MHz • Tuning Voltage: 0.5 - 8 Vdc • MINI-16HT - Style Package APPLICATIONS • Basestations • Satellite Communications • PERFORMANCE SPECIFICATIONS Oscillation Frequency Range Phase Noise @ 10 kHz offset (1 Hz BW, typ.) Harmonic Suppression (2nd, typ.) Tuning Voltage Tuning Sensitivity (avg.) Power Output Load Impedance Input Capacitance (max.) Pushing Pulling ( 14 dB Return Loss, Any Phase) £(f) (dBc/Hz) OFFSET (Hz) VALUE 6390 - 6770 -86 -20 0.5 - 8 80 3±3 50 10 <8 <4 -40 to 85 MINI-16HT 8 25 APPLICATION NOTES Vdc mA pF MHz/V MHz °C UNITS MHz dBc/Hz dBc Vdc MHz/V dBm Operating Temperature Range Package Style POWER SUPPLY REQUIREMENTS Supply Voltage (Vcc, nom.) Supply Current (Icc, typ.) All specifications are typical unless otherwise noted and subject to change without notice. • AN-100/1 : Mounting and Grounding of VCOs • AN-102 : Proper Output Loading of VCOs • AN-107 : How to Solder Z-COMM VCOs NOTES: Phase Noise @ 1 kHz offset (1 Hz BW, max.): -82dBc/Hz © Z-Communications, Inc. Page 1 All rights reserved LOW COST - HIGH PERFORMANCE VOLTAGE CONTROLLED OSCILLATOR TUNING CURVE, typ. 6840 6800 6760 6720 6680 6640 6600 6560 6520 6480 6440 6400 6360 6320 6280 6240 6200 6160 0 1 2 3 4 5 6 CLV6580A-LF PAGE 2 FREQUENCY (MHz) 85 25 -40 °c °c °c 7 8 TUNING VOLTAGE (Vdc) POWER CURVE, typ. POWER OUTPUT (dBm) 10 9 8 7 6 5 4 3 2 1 0 6206 6314 6409 6507 6605 6689 6749 6786 6808 85 25 -40 °c °c °c FREQUENCY (MHz) PHYSICAL DIMENSIONS P1 Vt P2 RF P3 Vcc Z-COMM XXXXXXXX-LF W/O# D/C NOTES 1. The inside radius of all 16 half holes at the perimeter of the board are plated to provide a surf ace for the attachment of the VCO Module to the PCB. 13 pads are f or grounding, 3 pads are f or RFout and pow er supplies. 2. The surf ace of the shield is tin-plated and may be soldered to The shield's base metal is cold rolled steel. 3.The ground plane on the bottom side is ground and attaches to a ground track on the top side of the board as w ell as to the shield. 4. Unless otherw ise noted all dimensions are in inches. 5. Unless otherw ise noted all tolerances are as f ollow s: .xxx = ± .010 © Z-Communications, Inc. Page 2 Printed in the U.S.A.