SCHOTTKY RECTIFIER

Bulletin PD-21090 rev. A 05/06 12CWQ10FNPbF SCHOTTKY RECTIFIER 12 Amp IF(AV) = 12Amp VR = 100V Major Ratings and Characteristics Characteristics IF(AV) Rectangular waveform VRRM www.DataSheet4U.com Description/ Features Units A V A V The 12CWQ10FNPbF surface mount, center tap, Schottky rectifier series has been designed for applications requiring low forward drop and small foot prints on PC board. Typical applications are in disk drives, switching power supplies, converters, freewheeling diodes, battery charging, and reverse battery protection. Popular D-PAK outline Center tap configuration Small foot print, surface mountable Low forward voltage drop High frequency operation Guard ring for enhanced ruggedness and long term reliability Lead-Free ("PbF" suffix) Values 12 100 330 0.65 IFSM @ tp = 5 μs sine VF TJ @ 6 Apk, TJ = 125°C (per leg) range - 55 to 150 °C Case Styles Base Common Cathode 4 2 Common 1 Cathode 3 Anode Anode D-PAK (TO-252AA) www.irf.com 1 12CWQ10FNPbF Bulletin PD-21090 rev. A 05/06 Voltage Ratings Part number V R Max. DC Reverse Voltage (V) VRWM Max. Working Peak Reverse Voltage (V) 12CWQ10FNPbF 100 Absolute Maximum Ratings Parameters IF(AV) Max. Average Forward Current * See Fig. 5 IFSM EAS IAR (Per Leg) (Per Device) 12CWQ... Units 6 12 330 110 6 1 A mJ A A Conditions 50% duty cycle @ TC = 135°C, rectangular wave form 5μs Sine or 3μs Rect. pulse Following any rated load condition and with 10ms Sine or 6ms Rect. pulse rated VRRM applied Max.PeakOneCycleNon-Repetitive Surge Current * See Fig. 7(Per Leg) Non-Repetit. AvalancheEnergy(PerLeg) RepetitiveAvalancheCurrent(PerLeg) TJ = 25 °C, IAS = 1 Amps, L = 12 mH Current decaying linearly to zero in 1 μsec Frequency limited by TJ max. VA = 1.5 x VR typical Electrical Specifications Parameters VFM Max. Forward Voltage Drop (Per Leg) * See Fig. 1 (1) 12CWQ... Units 0.80 0.95 0.65 0.78 1 4 0.47 20.68 183 5.0 V V V V mA mA V mΩ Conditions @ 6A @ 12A @ 6A @ 12A TJ = 25 °C TJ = 125 °C TJ = TJ max. TJ = 25 °C TJ = 125 °C VR = rated VR IRM Max. Reverse Leakage Current (Per Leg) * See Fig. 2 (1) VF(TO) Threshold Voltage rt CT LS Forward Slope Resistance Typ. Junction Capacitance (Per Leg) Typical Series Inductance (Per Leg) pF nH VR = 5VDC, (test signal range 100Khz to 1Mhz) 25°C Measured lead to lead 5mm from package body (1) Pulse Width < 300μs, Duty Cycle <2% Thermal-Mechanical Specifications Parameters TJ Tstg Max. Junction Temperature Range (*) Max. Storage Temperature Range 12CWQ... Units -55 to 150 -55 to 150 3.0 1.5 0.3 (0.01) g (oz.) °C °C Conditions RthJC Max. Thermal Resistance (Per Leg) Junction to Case wt Approximate Weight Case Style Marking Device (*) dPtot dTj < 1 Rth( j-a) °C/W DC operation * See Fig. 4 (PerDevice) D-Pak 12CWQ10FN Similar to TO-252AA thermal runaway condition for a diode on its own heatsink 2 www.irf.com 12CWQ10FNPbF Bulletin PD-21090 rev. A 05/06 1000 100 10 1 0.1 0.01 0.001 0.0001 TJ= 150°C 125°C 100°C 75°C 50°C 25°C Instantaneous Forward Current - I F (A) 100 R everse Current - I R (mA) 0 10 20 30 40 50 60 70 80 90 100 Reverse Voltage - V R (V) TJ = 150°C TJ = 125°C 10 Fig. 2 - Typical Values Of Reverse Current Vs. Reverse Voltage (Per Leg) 1000 Junction Capacitanc e - C T (pF) TJ = 25°C TJ= 25°C 100 1 0 0.5 1 1.5 2 2.5 3 3.5 10 0 20 40 60 80 100 Forward Voltage Drop - VFM (V) Reverse Voltage - V R(V) Fig. 1 - Max. Forward Voltage Drop Characteristics (Per Leg) 10 T hermal Impedance Z thJC (°C/W) Fig. 3 - Typical Junction Capacitance Vs. Reverse Voltage (Per Leg) 1 D = 0.75 D = 0.50 D = 0.33 D = 0.25 D = 0.20 P DM 0.1 Notes: S ingle Pulse (T hermal R esistanc e) 0.01 0.00001 0.0001 0.001 0.01 t1 t2 1. Duty factor D = t 1/ t 2 2. Peak T = PDM x Z thJC+ TC J 0.1 1 t 1 , Rectangular Pulse Duration (S onds) ec Fig. 4 - Max. Thermal Impedance ZthJC Characteristics (Per Leg) www.irf.com 3 12CWQ10FNPbF Bulletin PD-21090 rev. A 05/06 150 Allowable Case T emperature - (°C) Average Power Loss - (Watts) 6 5 4 3 2 1 0 D = 0.20 D = 0.25 D = 0.33 D = 0.50 D = 0.75 RMSLimit DC 145 DC 140 135 130 125 see note (2) S quare wave (D = 0.50) 80% Rated V R applied 120 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 Average Forward Current - I F(AV) (A) Average Forward Current - I F(AV) (A) Fig. 5 - Max. Allowable Case Temperature Vs. Average Forward Current (Per Leg) Non-Repetitive S urge Current - I FSM (A) 1000 Fig. 6 - Forward Power Loss Characteristics (Per Leg) At Any R ated Load Condition And With Rated V RRM Applied Following S urge 100 10 100 1000 10000 S quare Wave Pulse Duration - t p (microsec) Fig. 7 - Max. Non-Repetitive Surge Current (Per Leg) (2) Formula used: TC = TJ - (Pd + PdREV) x RthJC ; Pd = Forward Power Loss = IF(AV) x VFM @ (IF(AV) / D) (see Fig. 6); PdREV = Inverse Power Loss = VR1 x IR (1 - D); IR @ VR1 = 80% rated VR 4 www.irf.com 12CWQ10FNPbF Bulletin PD-21090 rev. A 05/06 Outline Table Modified JEDEC outline TO-252AA Dimensions in millimeters and (inches) Part Marking Information PART NUMBER 12CWQ10FN THIS IS A 12CWQ10FN INTERNATIONAL RECTIFIER LOT CODE 8024 LOGO ASSEMBLED ON WW 02, 2000 ASSEMBLY LOT CODE DATE CODE P = LEAD-FREE YEAR 0 = 2000 WEEK 02 X = SITE ID www.irf.com 5 12CWQ10FNPbF Bulletin PD-21090 rev. A 05/06 Tape & Reel Information 1.85 (0.07) DIA. 1.65 (0.06) 1.85 (0.07) 1.65 (0.06) 7.6 (0.30) 7.4 (0.29) 12.1 (0.48) 11.9 (0.47) 2.6 (0.10) DIA. 1.5 (0.06) 0.35 (0.01) 0.25 (0.01) 16.3 (0.64) 15.7 (0.62) 4.1 (0.16) 3.9 (0.15) TR 2.1 (0.83) 1.9 (0.07) 7.0 (0.28) 6.8 (0.26) 2.75 (0.11) 2.55 (0.10) FEED DIRECTION 4.1 (0.16) 3.9 (0.15) TRR 2.1 (0.83) 1.9 (0.07) 1.85 (0.07) DIA. 1.65 (0.06) 1.85 (0.07) 1.65 (0.06) 7.6 (0.30) 7.4 (0.29) 0.35 (0.01) 0.25 (0.01) 10.6 (0.42) 10.4 (0.41) 2.75 (0.11) 2.55 (0.10) 16.3 (0.64) 15.7 (0.62) FEED DIRECTION 8.1 (0.32) 7.9 (0.31) 2.6 (0.10) DIA. 1.5 (0.06) 1.85 (0.07) DIA. 1.65 (0.06) 1.85 (0.07) 1.65 (0.06) 7.6 (0.30) 7.4 (0.29) 4.1 (0.16) 3.9 (0.15) TRL 2.1 (0.83) 1.9 (0.07) 0.35 (0.01) 0.25 (0.01) 16.3 (0.64) 15.7 (0.62) 10.6 (0.42) 10.4 (0.41) 2.75 (0.11) 2.55 (0.10) FEED DIRECTION 8.1 (0.32) 7.9 (0.31) 2.6 (0.10) DIA. 1.5 (0.06) 13 (0.52) DIA. 22.4 (0.88) TO-252AA Tape & Reel When ordering, indicate the part number, part orientation, and the quantity. Quantities are in multiples of 2,000 pieces per reel for TR and multiples of 3,000 pieces per reel for both TRL and TRR. 375 (14.17) DIA. MAX. 50 (1.97) DIA. 6 www.irf.com 12CWQ10FNPbF Bulletin PD-21090 rev. A 05/06 Ordering Information Table Device Code 12 1 C 2 W 3 Q 4 10 5 FN TRL PbF 6 7 8 1 2 3 4 4 5 6 7 - Current Rating (12A) Center Tap ConfigurationPackage Identifier W = D-Pak Schottky "Q" Series Voltage Rating (10 = 100V) FN = TO-252AA none = Tube (50 pieces) TR = Tape & Reel TRL = Tape & Reel (Left Oriented) TRR = Tape & Reel (Right Oriented) 8 - none = Standard Production PbF = Lead-Free Data and specifications subject to change without notice. This product has been designed and qualified for Consumer Level and Lead-Free. Qualification Standards can be found on IR's Web site. IR WORLD HEADQUARTERS: 233 Kansas St., El Segundo, California 90245, USA Tel: (310) 252-7105 TAC Fax: (310) 252-7309 Visit us at www.irf.com for sales contact information. 05/06 www.irf.com 7