SOLENOID DRIVER + SWITCH MODE POWER SUPPLY
OPERATING SUPPLY VOLTAGE UP TO 46V
1A POWER SUPPLY (5V)
5A SOLENOID DRIVER
PRECISE ON CHIP REFERENCE VOLTAGE
DISCONTINUOUS MODE - FREQUENCY
VERY HIGH EFFICIENCY
1Ω OUTPUT DMOS (SMPS)
INTERNAL CURRENT LIMIT (SMPS SEC-
EXTERNALLY PROGRAMMABLE SOLENOID
CURRENT RISING SLOPE
EXTERNALLY PROGRAMMABLE FIXED
OPTIMIZED DMOS RDS ON FOR HIGH SIDE
The L6213 is an IC containing a S.M.P.S. deliver-
ing 1A at a voltage of 5V and a section designed
to drive a solenoid with a current up to 5A.
The device is realized in BCD mixed technology,
which combines isolated DMOS power transistor
with CMOS and Bipolar circuits on the same chip.
The SMPS section can deliver 1A DC with an out-
MULTIPOWER BCD TECHNOLOGY
put voltage of 5V, including current limiting, reset
and power fail for microprocessor and thermal
The solenoid driver section is designed for high
current applications like hammer driver in elec-
The solenoid output section contains a high side and
a low side DMOS, which RDS ON are optimized for
high side chopping. The current rising slope is exter-
nally programmable through an external capacitor.
The level of hysteresis of the current can be
changed through an external resistor.
The device is supplied in Powerdip 16+2+2, and
use the four center pins to conduct heat to the
This is advanced information on a new product now in development or undergoing evaluation. Details are subject to change without notice.