http://www.www.datasheet4u.com

900,000+ Datasheet PDF Search and Download

Datasheet4U offers most rated semiconductors datasheets pdf




  ON Semiconductor Electronic Components Datasheet  

CAT25128 Datasheet

128-Kb SPI Serial CMOS EEPROM

No Preview Available !

CAT25128 pdf
CAT25128
128-Kb SPI Serial CMOS
EEPROM
Description
The CAT25128 is a 128Kb Serial CMOS EEPROM device
internally organized as 16Kx8 bits. This features a 64byte page write
buffer and supports the Serial Peripheral Interface (SPI) protocol. The
device is enabled through a Chip Select (CS) input. In addition, the
required bus signals are clock input (SCK), data input (SI) and data
output (SO) lines. The HOLD input may be used to pause any serial
communication with the CAT25128 device. The device features
software and hardware write protection, including partial as well as
full array protection.
OnChip ECC (Error Correction Code) makes the device suitable
for high reliability applications.*
Features
20 MHz SPI Compatible
1.8 V to 5.5 V Supply Voltage Range
SPI Modes (0,0) & (1,1)
64byte Page Write Buffer
Additional Identification Page with Permanent Write Protection
Selftimed Write Cycle
Hardware and Software Protection
Block Write Protection
Protect 1/4, 1/2 or Entire EEPROM Array
Low Power CMOS Technology
1,000,000 Program/Erase Cycles
100 Year Data Retention
Industrial and Extended Temperature Range
8lead PDIP, SOIC, TSSOP and 8pad TDFN, UDFN Packages
This Device is PbFree, Halogen Free/BFR Free, and RoHS
Compliant
VCC
SI
CS
WP
HOLD
SCK
CAT25128
SO
VSS
Figure 1. Functional Symbol
* Available for New Product (Rev. E)
© Semiconductor Components Industries, LLC, 2014
February, 2014 Rev. 8
1
http://onsemi.com
SOIC8
V SUFFIX
CASE 751BD
TDFN8**
VP2 SUFFIX
CASE 511AK
UDFN8
HU4 SUFFIX
CASE 517AZ
PDIP8
L SUFFIX
CASE 646AA
TSSOP8
Y SUFFIX
CASE 948AL
SOIC8
X SUFFIX
CASE 751BE
PIN CONFIGURATION
CS 1
SO
VCC
HOLD
WP SCK
VSS SI
PDIP (L), SOIC (X, V),
TSSOP (Y), TDFN** (VP2), UDFN (HU4)
** The TDFN8 (VP2) package is not recommended
for new designs.
PIN FUNCTION
Pin Name
Function
CS Chip Select
SO Serial Data Output
WP Write Protect
VSS Ground
SI Serial Data Input
SCK
Serial Clock
HOLD
Hold Transmission Input
VCC Power Supply
†The exposed pad for the TDFN/UDFN packages can
be left floating or connected to Ground.
ORDERING INFORMATION
See detailed ordering and shipping information in the package
dimensions section on page 19 of this data sheet.
Publication Order Number:
CAT25128/D


  ON Semiconductor Electronic Components Datasheet  

CAT25128 Datasheet

128-Kb SPI Serial CMOS EEPROM

No Preview Available !

CAT25128 pdf
CAT25128
Table 1. ABSOLUTE MAXIMUM RATINGS
Parameters
Ratings
Units
Operating Temperature
45 to +130
°C
Storage Temperature
65 to +150
°C
Voltage on any Pin with Respect to Ground (Note 1)
0.5 to +6.5
V
Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality
should not be assumed, damage may occur and reliability may be affected.
1. The DC input voltage on any pin should not be lower than 0.5 V or higher than VCC + 0.5 V. During transitions, the voltage on any pin may
undershoot to no less than 1.5 V or overshoot to no more than VCC + 1.5 V, for periods of less than 20 ns.
Table 2. RELIABILITY CHARACTERISTICS (Note 2)
Symbol
Parameter
Min Units
NEND (Notes 3, 4) Endurance
1,000,000
Program / Erase Cycles
TDR Data Retention
100 Years
2. These parameters are tested initially and after a design or process change that affects the parameter according to appropriate AECQ100
and JEDEC test methods.
3. Page Mode, VCC = 5 V, 25°C.
4. The new product revision (E) uses ECC (Error Correction Code) logic with 6 ECC bits to correct one bit error in 4 data bytes. Therefore, when
a single byte has to be written, 4 bytes (including the ECC bits) are reprogrammed. It is recommended to write by multiple of 4 bytes in order
to benefit from the maximum number of write cycles.
Table 3. D.C. OPERATING CHARACTERISTICS MATURE PRODUCT
(VCC = 1.8 V to 5.5 V, TA = 40°C to +85°C and VCC = 2.5 V to 5.5 V, TA = 40°C to +125°C, unless otherwise specified.)
Symbol
Parameter
Test Conditions
Min Max
Units
ICCR
Supply Current
(Read Mode)
Read, VCC = 5.5 V,
SO open
10 MHz / 40°C to 85°C
5 MHz / 40°C to 125°C
2 mA
2 mA
ICCW
Supply Current
(Write Mode)
Write, VCC = 5.5 V,
SO open
10 MHz / 40°C to 85°C
5 MHz / 40°C to 125°C
4 mA
4 mA
ISB1 Standby Current
VIN = GND or VCC, CS = VCC,
WP = VCC, HOLD = VCC,
VCC = 5.5 V
TA = 40°C to +85°C
TA = 40°C to +125°C
1 mA
3 mA
ISB2 Standby Current
VIN = GND or VCC, CS = VCC,
WP = GND, HOLD = GND,
VCC = 5.5 V
TA = 40°C to +85°C
TA = 40°C to +125°C
4 mA
5 mA
IL Input Leakage Current VIN = GND or VCC
2 2 mA
ILO
Output Leakage
Current
CS =
VOUT
V=CGCN, D
or
VCC
TA = 40°C to +85°C
TA = 40°C to +125°C
1
1
1 mA
2 mA
VIL Input Low Voltage
0.5
0.3 VCC
V
VIH Input High Voltage
0.7 VCC
VCC + 0.5
V
VOL1
Output Low Voltage
VCC > 2.5 V, IOL = 3.0 mA
0.4 V
VOH1
Output High Voltage
VCC > 2.5 V, IOH = 1.6 mA
VCC 0.8 V
V
VOL2
Output Low Voltage
VCC > 1.8 V, IOL = 150 mA
0.2 V
VOH2
Output High Voltage
VCC > 1.8 V, IOH = 100 mA
VCC 0.2 V
V
Product parametric performance is indicated in the Electrical Characteristics for the listed test conditions, unless otherwise noted. Product
performance may not be indicated by the Electrical Characteristics if operated under different conditions.
http://onsemi.com
2


Part Number CAT25128
Description 128-Kb SPI Serial CMOS EEPROM
Maker ON Semiconductor
Total Page 20 Pages
PDF Download
CAT25128 pdf
Download PDF File
[partsNo] view html
View PDF for Mobile






Related Datasheet

1 CAT25128 128-Kb SPI Serial CMOS EEPROM ON Semiconductor
ON Semiconductor
CAT25128 pdf






Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z

site map

webmaste! click here

contact us

Buy Components