http://www.www.datasheet4u.com

900,000+ Datasheet PDF Search and Download

Datasheet4U offers most rated semiconductors datasheets pdf





Connor-Winfield
Connor-Winfield

OFC5DJ3BS Datasheet Preview

OFC5DJ3BS Datasheet

Crystal Controlled Oscillators

No Preview Available !

OFC5DJ3BS pdf
THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX (630) 851-5040.
PHONE (630) 851-4722.
www.conwin.com
PRODUCT DATA
CRYSTAL CONTROLLED OSCILLATORS
SHEET
SURFACE MOUNT 5.0V OCXO with SINEWAVE OUTPUT
ABSOLUTE M AXIMUM RATING S
TABLE 1.0
PARAMETER
Storage Temperature
Supply Voltage
UNITS
(Vcc)
MINIMUM
-40
-0.5
NOMINAL
-
-
MAXIMUM
85
7
UNITS
°C
Vdc
NOTE
OFC5mDJ3BSOPERATING SPECIFICATIONS
PARAMETER
oCenter Frequency
.cStandard Frequencies Available:
Frequency Calibration
Frequency vs. Temperature Stability
Frequency vs. Voltage Stability (+/-5%)
UFrequency vs. Load Stability (+/-5%)
Aging: Daily
t4Aging: First Year
Aging: Long Term (20 Years)
Total Frequency Tolerance (20 years)
eAllen Variance: 1 second, 100 average.
Operating Temperature Range
eSupply Voltage
Power Consumption: Turn On
hPower Consumption: Steady-State
Start-Up Time
SWarm Up
(Fo)
(Vcc)
MINIMUM NOMINAL MAXIMUM UNITS
10 -
20 MHz
10 MHZ, 13 MHz, 15 MHZ, or 20 MHz
-0.2 0.2 ppm
-20 -
20 ppb
-2 - 2 ppb
-2 - 2 ppb
-1 - 1 ppb/day
-50 -
50 ppb
-250 - 250 ppb
-500 - 500 ppb
- 1.00E-10 -
RMS
-20 -
70 °C
4.75 5.00 5.25 Vdc
- - 3.25 W
- - 1. 5 W
500 mS
-100 - 100 ppb
TABLE 2.0
NOTE
1
2
3
4
5
6
6
7
8
taSINEWAVE OUTPUT CHARACTERISTICS
PARAMETER
LOAD
aOutput Power
Spurious Output
SSB Phase Noise at 1Hz offset
.DSSB Phase Noise at 10Hz offset
SSB Phase Noise at 100Hz offset
SSB Phase Noise at 1KHz offset
wSSB Phase Noise at 10KHz offset
MINIMUM
45
0
-
-
-
-
-
NOMINAL
50
3
-85
-110
-135
-150
-155
MAXIMUM
55
-
-80
-
-
-
-
-
UNITS
Ohms
dBm
dBc
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
TABLE 3.0
NOTE
RESTABILIZATION TIME
wOff Time
< 1 Hour
< 6 Hours
w m< 24 Hours
o1 to 16 Days
.c> 16 Days
Restabilization Time
< 2 Hours
< 12 Hours
< 48 Hours
48 Hours + ¼ Off Time
< 6 Days
TABLE 4. 0
NOTE
9
9
9
9
9
UPACKAG E CHARACTERISTICS
TABLE 5.0
t4Package
Non-hermetic package consisting of an FR4 substrate with grounded metal
cover.
eENVIRONMNETAL CHARACTERISTICS
TABLE 6.0
eShock
100G’s, 6mS, halfsine per MIL-STD-202F, Method 213B, Test Condition C
hVibration
0.06” D.A. or 10G peak 10 to 500 Hz, per MIL-STD-202F, Method 204D,
Test condition A
OFC5DtaJ3SBS - 10.00MHzPROCESS RECOMMENDATIONS
TABLE 7.0
Solder Reflow
The component solder used internal to this device has a melting point of
a221°C. The peak temperature inside the device should be less than or equal
to 220°C for a maximum of 10 seconds
.DWash
Ultrasonic cleaning is not recommended.
DESCRIPTION
The Connor-Winfield
OFC5DJ3BS is a 5V Surface
Mount Oven Controlled Crystal
Oscillator (OCXO) with a
Sinewave output. The
OFC5J3BS is designed for
Wireless applications requiring
low Phase Noise and tight
frequency stability.
FEATURES
FIXED FREQUENCY OCXO
FREQUENCY STABILITY: ±20ppb
TEMERATURE RANGE: -20 to 70°C
5.0V OPERATION
SINEWAVE OUTPUT
LOW PHASE NOISE
SURFACE MOUNT PACKAGE
TAPE AND REEL PACKAGING
ORDERING INFORMATION
OCXO
SERIES
CENTER
FREQUENCY
wwwDATASHEET #: Cx067 PAGE 1 OF 2
REV: 03
DATE: 10/04/05
Specifications subject to change without notice.
aCopyright 2001 Connor-Winfield all rights reserved.



Connor-Winfield
Connor-Winfield

OFC5DJ3BS Datasheet Preview

OFC5DJ3BS Datasheet

Crystal Controlled Oscillators

No Preview Available !

OFC5DJ3BS pdf
THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX (630) 851-5040.
PHONE (630) 851-4722.
www.conwin.com
PRODUCT DATA
CRYSTAL CONTROLLED OSCILLATORS
SHEET
Notes:
1) Labels will include the calibr ation frequency at the time of ship.
2) Initial calibration @ 25°C at the time of shipment.
3) Overall frequency stability ref erenced to measurement at 25°C.
4) After ten days of continuous operation.
5) Inclusive of calibration, freq uency stability vs. change in tem perature, supply voltage
change, load change, hock and vibration, 20 years aging.
6) Vcc = 5.0Vdc.
7) From Vcc=90% of final value. No m ore than 16 transitions at start-up before oscillator
has started.
8) Measured @ 0°C, within 5 minutes, refer enced one hour after turn-on.
9) For a given off time, the time r equired to meet daily aging, short-term stability.
Pin
1
2
6
7
8
9
10
11
12
13
14
15
16
TABLE 8.0
Function
N/C
Ground
N/C
Ground
Vcc
Vcc
Ground
Ground
N/C
Ground
Output
Ground
N/C
Dimensional Tolerance:
±.005 (.127mm)
SUGGESTED PAD LAYOUT
12.7
Pin 1
.310
(7.87mm)
.110
(2.75mm)
.210
(5.33mm)
.210
(5.33mm)
KEEP OUT AREAS (3 PLACES)
.110
(2.75mm)
Vcc
10 GND
11 GND
12 NC
13 GND
14 OUT
15 GND
NC
Vcc
GND 7
NC 6
GND 2
NC
50 Ohm
DATASHEET #: Cx067
PAGE 2 OF 2
REV: 03
DATE: 10/04/05
Specifications subject to change without notice.
aCopyright 2001 Connor-Winfield all rights reserved.


Part Number OFC5DJ3BS
Description Crystal Controlled Oscillators
Maker Connor-Winfield
Total Page 2 Pages
PDF Download
OFC5DJ3BS pdf
Download PDF File
OFC5DJ3BS pdf
View for Mobile



Buy Electronic Components




Related Datasheet

1 OFC5DJ3BS Crystal Controlled Oscillators Connor-Winfield
Connor-Winfield
OFC5DJ3BS pdf






Part Number Start With

0    1    2    3    4    5    6    7    8    9    A    B    C    D    E    F    G    H    I    J    K    L    M    N    O    P    Q    R    S    T    U    V    W    X    Y    Z

site map

webmaste! click here

contact us

Buy Components